Citroen C1, Peugeot 107, 108 & Toyota Aygo Owners Club. (Discount code for CityBugStore: C1OC)

It is currently Sat Aug 15, 2020 3:06 pm

All times are UTC [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: MMT gearbox reset.
PostPosted: Sun Oct 12, 2014 9:03 pm 
Offline
Full Member

Joined: Mon Oct 17, 2011 7:57 pm
Posts: 77
Drives: Peugeot 107 2tronic
I thought people on here with the MMT gearbox may find it useful to know it is possible to reset the gearbox ecu after a clutch change WITHOUT resorting to dealers or purchasing any expensive equipment.

1, Search Google for the Blue Print MMT Technical Bulletin and print it off.

2, BEFORE you strip any parts off the car it is important you follow the instructions carefully and put the clutch actuator in the "clamp" position.

3, Remove the gearbox in the normal way, I found it helpful to remove the radiator to prevent damaging it and to improve access, the gearbox is more difficult to get in and out than the manual version because the actuators add weight and bulk. Replace the clutch and put it all back together again.

4, This is the part that's not in the Blue Print instructions. Loosen the three 12mm headed bolts which hold down the clutch actuator (which will still be in the "clamp" position) on top of the gearbox and slide it in it's slots until the operating rod on the actuator is JUST touching the clutch leaver, there should be NO free play.

5, Continue following the Blue Print instructions.

6, My car is changing gears perfectly, smooth and precise.

It may also be of interest to know I bought two new drive shaft nuts for less than £4 posted from J and R CV Joints via Ebay, these are listed for a Toyota Yaris. They arrived next day, and fit perfectly so a big thumbs up.

I hope you find this is of use.


Top
 Profile  
 
 Post subject: Re: MMT gearbox reset.
PostPosted: Thu Oct 08, 2015 6:05 pm 
Offline

Joined: Sat Sep 26, 2015 6:05 pm
Posts: 7
Drives: peugeot 107 2009
Hi there I tried the same but didn't work on my 2009 107 any clue


Sent from my iPad using Tapatalk


Top
 Profile  
 
 Post subject: Re: MMT gearbox reset.
PostPosted: Sat Aug 01, 2020 3:09 pm 
Offline

Joined: Sat Aug 01, 2020 3:03 pm
Posts: 1
Drives: pug 107
hi guys when setting up clutch actuator should it be fully out ?
also who uses clutch spring compressor tool to instal clutch to flatten springs
as i have just installed new clutch and to set it i used the clutch tool but think its positioned wrong

c :wave: heers guys


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group